| Standard
Features on all
7' Wide Slant Load Trailers |
- 85.5" Outside Body
Width
- 82.25" Inside Body
Width
- 7' Inside Height
- 7' 6" Gooseneck Length
- Available in Pre-painted
White Skin or With Partially Extruded Sides (horse
area only) White Skin On Smooth Areas.
- Tapered Nose with Stainless
Steel Front Sheet
- Breakaway Switch w/Battery
- Catwalks Full Length On
Outside
- Silver Modular Wheels
- Hub and Nut Covers
- DOT Lighting
- Rubber Bumper
- All Wheel Electric Brakes
- Two Safety Chains
- Hold Backs On All Exterior
Doors
- One Saddle Rack Per Stall
(up to four)
- 12,000 lb. Drop Leg Gooseneck
Jack
|
|
| Standard
Horse Area Features |
- Rubber Floor Mats
- Rubber Kick Mat On Side
Walls
- One Two-Way Roof Vent Per
Stall
- Collapsible Rear Tack
- 60/40 Rear Doors With 18"
x 24" Windows
- Removable Rear Post
- Two Tie Loops Per Stall
- Slam Latches On Dividers
- Interior Side Wall Lined
and Insulated to Roof
- Six Bridle Hooks in Rear
Tack
- Minimum of Three Dome Lights
- 18" x 24" Windows
With Guards Behind Horses
- Drop Down Feed Doors with
Window and Drop Down Guards
- Feed Bag Rings
- Padded Butt Bar Across
Rear Opening
|
| |
| Standard
Dressing Room Features |
- 32" x 72"
Premium Camper Door with Screen
- Carpet on Floor
- Clothes Bar
- Brush Box
- Two Dome Lights
- Bridle Hooks
- Ceiling Vents
- Red Skin Genesis
- Drop Down Feed Doors and
Drop
- Down Guards
- Air Flow Dividers
|
|
| Standard |
- Spare Tire and Wheel
- Red or Black Skin
- Tailwind
- Horse Combo
- Mid Tacks
- Side Mangers
- Side Mangers w/ Access
Doors
|
| |
| Trailer |
- Spare Tire
- Tailwind w/Plexiglass
- Red Skin
- Red or Black Skin
- Side Mangers w/access doors
- Mid Tack Door
|
| |
| Slide
Out Rules |
- Measurement for height
is from top of existing frame rail {not floor}
- No slide out AND camper
door on the same sidewall
- No more than one slide
out per unit.
- No device may be installed
on the sidewall that slide out is located on that
severs or cuts into any structural member intended
to add strength to slide out opening
- Additional exterior sheeting
shipped with unit to finish outside of slide out
box.(color match)
- These rough openings are
intended to be used with the "LIFTCO"
brand slide out assemblies.
- Framing for refrigerator
vent, hot water heater vent and furnace vent are
not included in these packages.
|
|
Slide
Out Options
7' wide Genesis
Slide out Standard Locations |
Package
#40
Slide out rough opening size
67.25" wide x 73.63" tall
- 13" back from GN
drop ONLY!!!
- Camper door- passenger
side ONLY!! 54" back from GN drop to front
of camper door opening.
- THIS PACKAGE AVAILABLE
ON 40" EXTENDED MODELS ONLY
Package #80
Slide out rough opening size
80.5" wide x 76.25" tall
- 13" back from GN
drop ONLY!!
- Camper door- passenger
side ONLY!! 63" back from GN drop to front
of camper door opening
- THIS PACKAGE AVAILABLE
ON 80"EXTENDED MODELS ONLY
Package #120
Slide out rough opening size
80.5" wide x 76.25" tall
- 13" back from GN
drop ONLY!
- Camper door- passenger
side ONLY!! 77" back from GN drop to front
of camper door opening.
- THIS PACKAGE AVAILABLE
ON 120" EXTENDED MODELS ONLY
|
| |
Slide
Out Options
8.5' wide Genesis
Slide out Standard Locations |
- There is only one size
of Slide out available on the 8.5' wide Genesis:
- Rough opening size is:
80.5" wide x 76.25" tall.
- Placement is on Drivers
side wall, 13" back from GN drop to the front
of rough opening.
- Height measurement is
from the top of the aluminum frame rail (not from
floor)
- The passenger side wall
is not affected by the addition of a slide out
to the opposite wall.
|
|
